The MicroMod M2 Module is a packaged version of the
MicroMod CPU. Since only a limited set of the Micromod's inputs and outputs can be brought out to the terminal blocks, several packaged versions are available in different configurations. The Mix 2 (M2) Version has a specific mixture of inputs and outputs:
2 digital inputs with following properties:
Pull-up or pull-down circuit
Voltage swing 5 to 18 V
Schmitt trigger behavior, inverting
Low-pass behavior
Parallel connection of a frequency input (for each digital input 0 to 3)
for alternative use (e.g. at fast changes of state, or at count)
2 temperature inputs for connection
of an NTC thermistor and a platinum sensor PT1000,
measuring range each 0 to 70 °C (32 to 158 °F)
3 analog inputs with following properties:
Pull-down circuit
Measuring range unipolar, 0 to 5 V
Measuring range extension possible Protection against
under voltage and over voltage
1 digital output with following properties:
fast low-side switches, max. 55 V, 0.75 A
Short circuit protection
1 analog output with following properties:
Voltage 0 to 10 V using PWM at a resolution of 16 bits
Load ability: 15 mA, short-circuit proof
1 analog output with current intensity 0 to 20 mA
using PWM at a resolution of 16 bits
Status LEDs for power supply and digital outputs
NOTE:Since the MicroMod is programmed and configured over the CAN network using the free PC software provided, a PEAK PC to CAN interface is required (sold separately). We recommend the
CAN-USB adapter as the simplest interface to use for this purpose.
